Displaying interface settings – Accton Technology ES3526XA User Manual

Page 171

Advertising
background image

Spanning Tree Algorithm Configuration

3-127

3

CLI – This example enables Spanning Tree Protocol, sets the mode to MST, and
then configures the STA and MSTP parameters.

Displaying Interface Settings

The STA Port Information and STA Trunk Information pages display the current
status of ports and trunks in the Spanning Tree.

Field Attributes
Spanning Tree – Shows if STA has been enabled on this interface.
STA Status – Displays current state of this port within the Spanning Tree:

- Discarding - Port receives STA configuration messages, but does not forward

packets.

- Learning - Port has transmitted configuration messages for an interval set by

the Forward Delay parameter without receiving contradictory information. Port
address table is cleared, and the port begins learning addresses.

- Forwarding - Port forwards packets, and continues learning addresses.

The rules defining port status are:
- A port on a network segment with no other STA compliant bridging device is

always forwarding.

- If two ports of a switch are connected to the same segment and there is no other

STA device attached to this segment, the port with the smaller ID forwards
packets and the other is discarding.

- All ports are discarding when the switch is booted, then some of them change

state to learning, and then to forwarding.

Forward Transitions – The number of times this port has transitioned from the

Learning state to the Forwarding state.

Designated Cost – The cost for a packet to travel from this port to the root in the

current Spanning Tree configuration. The slower the media, the higher the cost.

Designated Bridge – The bridge priority and MAC address of the device through

which this port must communicate to reach the root of the Spanning Tree.

Designated Port – The port priority and number of the port on the designated

bridging device through which this switch must communicate with the root of the
Spanning Tree.

Console(config)#spanning-tree

4-161

Console(config)#spanning-tree mode mstp

4-161

Console(config)#spanning-tree priority 40000

4-164

Console(config)#spanning-tree hello-time 5

4-163

Console(config)#spanning-tree max-age 38

4-164

Console(config)#spanning-tree forward-time 20

4-163

Console(config)#spanning-tree pathcost method long

4-165

Console(config)#spanning-tree transmission-limit 4

4-166

Console(config)#spanning-tree mst-configuration

4-166

Console(config-mstp)#revision 1

4-169

Console(config-mstp)#name R&D

4-168

Console(config-mstp)#max-hops 30

4-169

Console(config-mstp)#

Advertising
This manual is related to the following products: