Accton Technology ES3526XA - Manual (Page 196)

Configuring the Switch
3-152
3
CLI – This example sets port 3 to accept only tagged frames, assigns PVID 3 as the
native VLAN ID, enables GVRP, sets the GARP timers, and then sets the switchport
mode to hybrid.
Private VLANs
Private VLANs provide port-based security and isolation between ports within
the assigned VLAN. This switch supports two types of private VLANs: primary/
secondary associated groups, and stand-alone isolated VLANs. A primary VLAN
contains promiscuous ports that can communicate with all other ports in the private
VLAN group, while a secondary (or community) VLAN contains community ports
that can only communicate with other hosts within the secondary VLAN and with any
of the promiscuous ports in the associated primary VLAN. Isolated VLANs, on the
other hand, consist a single stand-alone VLAN that contains one promiscuous port
and one or more isolated (or host) ports. In all cases, the promiscuous ports are
designed to provide open access to an external network such as the Internet, while
the community or isolated ports provide restricted access to local users.
Multiple primary VLANs can be configured on this switch, and multiple community
VLANs can be associated with each primary VLAN. One or more isolated VLANs
can also be configured. (Note that private VLANs and normal VLANs can exist
simultaneously within the same switch.)
To configure primary/secondary associated groups, follow these steps:
1. Use the Private VLAN Configuration menu (page 3-154) to designate one or
more community VLANs, and the primary VLAN that will channel traffic outside
of the VLAN groups.
2. Use the Private VLAN Association menu (page 3-154) to map the secondary
(i.e., community) VLAN(s) to the primary VLAN.
3. Use the Private VLAN Port Configuration menu (page 3-156) to set the port
type to promiscuous (i.e., having access to all ports in the primary VLAN), or
host (i.e., having access restricted to community VLAN members, and
channeling all other traffic through promiscuous ports). Then assign any
promiscuous ports to a primary VLAN and any host ports a community VLAN.
To configure an isolated VLAN, follow these steps:
1. Use the Private VLAN Configuration menu (page 3-154) to designate an
isolated VLAN that will channel all traffic through a single promiscuous port.
Console(config)#interface ethernet 1/3 4-131
Console(config-if)#switchport acceptable-frame-types tagged 4-182
Console(config-if)#switchport ingress-filtering 4-183
Console(config-if)#switchport native vlan 3 4-184
Console(config-if)#switchport gvrp 4-195
Console(config-if)#garp timer join 20 4-196
Console(config-if)#garp timer leave 90 4-196
Console(config-if)#garp timer leaveall 2000 4-196
Console(config-if)#switchport mode hybrid 4-182
Console(config-if)#