Accton Technology ES3526XA - Manual (Page 89)

Configuring SNMPv3 Management Access
3-45
3
configure the remote agent’s SNMP engine ID before you can send proxy requests
or informs to it. (See “Specifying Trap Managers and Trap Types” on page 3-41 and
“Configuring Remote SNMPv3 Users” on page 3-47.)
The engine ID can be specified by entering 1 to 26 hexadecimal characters. If less
than 26 characters are specified, trailing zeroes are added to the value. For
example, the value “1234” is equivalent to “1234” followed by 22 zeroes.
Web – Click SNMP, SNMPv3, Remote Engine ID. Enter an ID of up to 26
hexadecimal characters and then click Save.
Figure 3-28 Setting an Engine ID
CLI – This example specifies a remote SNMPv3 engine ID.
Configuring SNMPv3 Users
Each SNMPv3 user is defined by a unique name. Users must be configured with a
specific security level and assigned to a group. The SNMPv3 group restricts users to
a specific read, write, or notify view.
Command Attributes
• User Name – The name of user connecting to the SNMP agent. (Range: 1-32
characters)
• Group Name – The name of the SNMP group to which the user is assigned.
(Range: 1-32 characters)
• Security Model – The user security model; SNMP v1, v2c or v3.
• Security Level – The security level used for the user:
- noAuthNoPriv – There is no authentication or encryption used in SNMP
communications. (This is the default for SNMPv3.)
- AuthNoPriv – SNMP communications use authentication, but the data is not
encrypted (only available for the SNMPv3 security model).
- AuthPriv – SNMP communications use both authentication and encryption (only
Console(config)#snmp-server engineID remote 54321 192.168.1.19 4-123
Console(config)#exit
Console#show snmp engine-id
4-124
Local SNMP engineID: 8000002a8000000000e8666672
Local SNMP engineBoots: 1
Remote SNMP engineID IP address
80000000030004e2b316c54321 192.168.1.19
Console#