Control Company 4351 KEY-CHAIN THERMOMETER - Manual

Figure 1.
1 2 3
Description
1 - ° C/ ° F Switch
2 - Display
3 - ON/OFF Switch
TRACEABLE® KEY-CHAIN THERMOMETER INSTRUCTIONS
Warranty, service, or recalibration
For warranty, service, or recalibration, contact:
CONTROL COMPANY
4455 Rex Road
Friendswood, Texas 77546 USA
Ph. 281 482-1714 Fax 281 482-9448
E-mail [email protected].
www.control3.com
Control Company is ISO 9001 Quality-Certified by DNV and
ISO 17025 accredited as a Calibration Laboratory by A2LA.
Cat. No. 4351
Traceable® Key-Chain Thermometer Instructions
92-4351-00
Rev. 2 122707
Traceable ® is a registered trademark of Control Company.
© 2007 Control Company
SPECIFICATIONS
Range: –58 to 302°F (–50 to 150°C)
Resolution: ±0.1° from –20.0 to 200.0°, 1° below
–20.0 and above 200.0°
Accuracy: ±1.0°C between –20.0 and 100°C
Sampling rate: 1 second in Celsius mode
10 seconds in Fahrenheit mode
Battery: Cat. No. 1039
Construction: Stainless steel and plastic
ALL OPERATIONAL DIFFICULTIES
If this thermometer does not function properly for any reason, please
replace the battery with a new high quality battery (see “Battery Re-
placement” section). Low battery power can occasionally cause any
number of “apparent” operational difficulties. Replacing the battery
with a new fresh battery will solve most difficulties.
BATTERY REPLACEMENT
Erratic readings, a faint display, or no display are all indications that
the battery is low and needs to be replaced. To replace the battery,
remove the battery cap ( located on the top of the unit and marked
open) by turning it in the direction of the arrow (counterclockwise).
Replace the exhausted battery with a new Cat. No. 1039 battery.
Make certain that the positive (+) side is facing you. Incorrectly
installed batteries may damage electronics. Replace
the Battery Cap.
OPERATION
1. Slide the ON/OFF switch (3, Fig. 1) to ON to turn the unit on.
2. Slide the °C/°F switch (1, Fig. 1) to °F to display the temperature
in Fahrenheit or to °C to display in Celsius.
3. Insert the stem into air, semi-solid, or liquid material to be mea-
sured.
4. Slide the ON/OFF switch (3, Fig. 1) to OFF to turn the unit off.
To conserve battery life, always turn the unit off when not in
use.