Bosch Dampfbügeleisen Sensixxx DA50 EditionRosso TDA503001P schwarz rot - Manual (Page 17)

17
B O S C H
EN
G
lI
SH
Trouble shooting
problem probable cause Solution
The iron does not
heat up.
1. Temperature control set to minimum.
2. No mains supply.
3. The “secure” system has been
activated. The iron is set to
stand-by.
1. Turn to a higher position.
2. Check with another appliance or
plug the iron into a different socket.
3. To reconnect the iron, just move it
about gently.
“Auto off” indicator
lamp lashes.
• The “secure” system has been
activated. The iron is set to stand-by.
• To reconnect the iron, just move it
about gently.
The clothes tend to
stick.
• The temperature is too high. • Turn the temperature control down and
wait until the iron has cooled down.
Water drips out of
the soleplate
together with steam.
1. Temperature control setting is too
low.
2. Steam control is set too high in
conjunction with a low temperature.
3. You have pressed the shot of steam
button repeatedly without waiting for
5 seconds between each press.
4. Pure distilled water has been used
(see “Filling the water tankk”
section) or other products such as
fragrant water have been added to
the tank.
1. Turn the temperature control to a
higher setting (between “••” and “max”)
and wait until the lamp goes out.
2. Set the steam control to a lower
setting.
3. Wait 5 seconds between each press
of the jet of steam button.
4. Mix distilled water with tap water as
directed in the “Filling the water tank”
section and never add any other
products to the water tank (unless
recommended by Bosch).
Steam does not
come out.
1. Steam control is set to “ ”
position.
2. No water in the tank.
3. The temperature is too low.
Anti-drip system is activated.
1. Set the steam control to an open
steam position.
2. Fill the tank.
3. Set to a higher temperature if
compatible with the fabric.
Spray does not
work.
1. No water in the tank.
2. Obstructed mechanism.
1. Fill the water tank.
2. Contact the Technical Service.
Smoke comes out
when connecting the
iron for the irst time.
• This may be caused by the
lubrication of some of the internal
parts.
• This is normal and will stop after a
few minutes.
Deposits come out
through the holes in
the soleplate
• Traces of lime scale are coming out
of the steam chamber.
• Carry out a cleaning cycle (see
“Calc'n clean” section).
If none of the above solves the problem, get in touch with an authorised technical service.
You can download this manual from the local homepages of Bosch.