PowerMadd CargoCaddy Universal 13730 - Manual

P
OWER
M
ADD
®
1-800-435-6881
www.powermadd.com
PP5011 REV B
P
OWER
M
ADD
®
Universal CargoCaddy
TM
Installation Instructions for Part No. 13730
HARDWARE INLCUDED: TOOLS REQUIERED: OTHER AVAILABLE MODELS:
Qty Description Power Drill Part No. Description
1 CargoCaddy 7/32” Drill Bit 13731 Polaris Edge Chassis
3 Dividers Pop Rivet Gun 13732 Arctic ZR Chassis, 2000 & newer
5 Foam Top Pads Center Punch (won’t fit ZR 800 or ZR 900)
1 Foam Bottom 13733 Ski-Doo MXZ Chassis
1 Spare Belt Bracket
6 3/16” Pop Rivets
WARNING: Read all instruction prior to installation. Never work on a snowmobile while snowmobile is running.
Before any drilling is done to your snowmobile, take adequate precautions to be sure no debris will end up in your
clutches or any other areas that may cause damage or injury. If possible, remove the clutch cover from the
snowmobile while drilling any holes or doing any riveting, this will make installation easier.
STEP 1: Remove any previously installed spare spark plug or drive belt
holders from the top of the clutch cover that will interfere with the
CargoCaddy.
STEP 2: Drill through the CargoCaddy at the two circled bosses located on
the bottom of the CargoCaddy using a 7/32” drill bit.
STEP 3: Place the CargoCaddy on top of the clutch cover and adjust its position so it does not interfere with
the hood or any cooling or control mechanisms when closed. NOTE: Hood foam above the
CargoCaddy may need to be removed in some snowmobiles to allow proper closer of hood.
STEP 4: With the CargoCaddy in the desired position on top of the clutch cover and the CargoCaddy lid
opened or removed, use a center punch to mark drill locations in the clutch cover at the holes in the
bottom of the CargoCaddy from STEP 2. Drill the holes in the clutch cover at the 2 locations using
a 7/32” drill bit.
STEP 5: Place the CargoCaddy back on the clutch cover with the belt clip sandwiched between the
CargoCaddy and the clutch cover. Using two rivets fasten the CargoCaddy and belt clip to the
cover using the two previously drilled holes.
STEP 6: On the inside bottom of the CargoCaddy are 6 numbered bosses, pick 4 of them which you can drill
through both the CargoCaddy and the clutch cover, and drill through using a 7/32” bit. Then use
the 4 remaining rivets to fasten the CargoCaddy to the clutch cover.