Bosch KGN49AI32 - Manual (Page 8)

en
8
ã=
Warning
While changing over the door hinges,
ensure that the appliance is not
connected to the power supply. Pull out
the mains plug beforehand. To prevent
damaging the back of the appliance,
place adequate padding underneath.
Carefully place the appliance on its back.
Change over the door hinges
in numerical sequence. Fig. 1
Note
If the appliance is placed on its back,
ensure that the wall spacer is not fitted.
Changing the door
handle
(if required)
Fig. 2
Change the door handle in numerical
sequence.
Fitting the wall spacer
Fig. 3
If available:
Fit wall spacers to obtain the indicated
energy rating of the appliance.
A reduced wall gap will not restrict
the function of the appliance. The energy
rating may then increase slightly.
Distance to the back wall
The distance of 75 mm must not be
exceeded.
Aligning the appliance
Place the appliance in the designated
location and align. The appliance must
be level. If the floor is uneven, use
the front height-adjustable feet. Adjust
the height-adjustable feet with a wrench.
Note
The appliance must be upright. Please
align it with a spirit level.