AMX AXB-TCR - Manual (Page 10)

Installation and Wiring
6 AXB-TC and AXB-TCR Television Controllers (& Receivers)
JI jumper settings: TV power sensing/TV power current sensing mode
J2 jumper settings: IR output mode (IR or serial communication)
J3 jumper settings: IR attenuation mode (bypass or adjustment)
JI Jumper Settings: TV Power Sensing/TV Power Current Sensing
Television Power Sensing mode To use this mode, connect a TVS TV Sensor
to the television to detect horizontal scan fre-
quencies up to 65 kHz.
Place the 2-pin jumper on the JP1 connector
pin's 1 and 2.
Television Power Current Sensing mode To use this mode, connect a sensor device
(such as a PCS2 Dual Power Current Sen-
sor or VSS2 Video Sync Sensor) to the
television to detect on and off power status.
Place the 2-pin jumper on the JP1 connector
pin's 2 and 3.
J2 Jumper Settings: IR Output Mode (IR or Serial Communication)
IR Output mode To use this mode, connect a CC-IRC IR
Emitter to the television to transmit IR sig-
nals.
Place the 2-pin jumper on the JP2 connector
pin's 2 and 3.
Serial (wired connection) Output mode Place the 2-pin jumper on the JP2 connector
pin's 1 and 2.
J3 Jumper Settings: IR Attenuation Mode (Bypass or Adjustment)
IR Signal Attenuation Bypass mode (normal) Place the 2-pin jumper on the JP3 connector
pin's 1 and 2.
IR Signal Attenuation Adjustment mode Place the 2-pin jumper on the JP3 connector
pin's 2 and 3.
Also, set the JP2 internal jumper for IR emit-
ter mode.
Refer to the product documentation for the PCS2 Dual Power Current Sensor, VSS2
Video Sync Sensor, TVS TV Sensor and CC-IRC IR Emitter (available online at
www.amx.com) for more information on these devices.