Emtech Electronics TTAIB - Manual

International Telephone Interface Instructions
(Satellite Receiver Cabinet Connection)
The telephone interface enables backup sound over a phone line for
satellite broadcasts in the event of a satellite failure.
Equipment Used:
1 – Telephone Interface Box
1 – RCA to RCA cable (6 feet)
1 – Telephone Cord (18 inches)
1 – Power Supply with International Adapters
Step 1: Disconnect the handset cord at the base of the telephone and
connect it to the interface box in the jack next to the picture of the
telephone handset.
Step 2: Connect one end of the provided telephone cord to the base of the
telephone and the other end to the interface box in the jack next to
the picture of the telephone.
Step 3: Connect one end of the RCA to RCA cable to the interface box in
the jack labeled LINE OUT. Connect the other end of the cable to
the AUDIO connector in the INPUTS section on the front of the
satellite equipment cabinet. Move the toggle switch labeled VCR-
OFF-SATELLITE to the VCR position.
Step 4: Connect the plug on the power supply cord to the interface box in
the jack indicating a +12VDC connection. Using the proper
adapter, plug the power supply into the building’s wall outlet.
Step 5: Call your area help desk to test the telephone connection volume
level and to connect your call to the broadcast phone bridge.
Insert a Phillips head into the unmarked hole in the face of the
interface box. Turn the screwdriver clockwise to increase the
volume and counter-clockwise to decrease the volume.
Step 6: After you have placed the call and are connected to the broadcast
phone bridge, leave the handset off the telephone and unplug the
handset’s cord attached to the interface box from the jack next to
the picture of the telephone handset.