Bosch KDD74AL20N Frigo-congelatore da libero posizionamento Inox look - Manual (Page 11)

en
11
Switching on the
appliance
The appliance starts to cool after it is
connected to the power supply. The
lighting is switched on when the door is
opened.
An acoustic warning tone sounds. The
"alarm" button can be used to switch off
the audible warning signal.
The factory has recommended and set
the following temperatures:
■
Fridge compartment: +4 °C
■
Freezer compartment: -18 °C.
Notes on using the appliance
■
After switching on the appliance, it
may be several hours before the set
temperatures are reached.
■
Thanks to the fully automatic no-frost
system, the freezer compartment
remains ice-free. There is no longer
any need to defrost it.
■
The front side of the housing is slightly
heated. This prevents condensation
from forming around the door seal.
■
If the freezer compartment drawer
cannot be opened again soon after
being closed, wait for a moment until
the negative pressure has cleared.
Setting the
temperature
Figure "
Cooling compartment
The temperature can be set from +2 °C
up to +8 °C.
Press button 4, "fridge/super", repeatedly
until display panel 5 displays the
required refrigerator compartment
temperature.
The last set value is saved.
Notes
■
Do not store perishable foods at
temperatures higher than +4 °C.
■
For short-term storage of food, a
higher temperature can be set
(energy-saving operation).
■
When frequently opening the door and
placing large quantities of food in the
cooling compartment, a lower
temperature should be set.
Freezer compartment
The temperature can be set from -15 °C
up to -22 °C.
Press the "freezer/super" button 1
repeatedly until the display panel 7
shows that the required freezer
compartment temperature is set.
The last set value is saved.