Hauler Racks SERVICE BODY ‘C’ MOUNT RACKS User Manual

Hauler Racks For the car

Advertising
background image

ASSEMBLY INSTRUCTIONS FOR

SERVICE BODY ‘C’ MOUNT RACKS

Service Body ‘C’ shown

HAULER RACKS, INC.

Toll Free: 1-800-843-5445

7109 31

st

Avenue North Phone: 763-546-5620

Minneapolis, MN 55427-2848 Fax: 763-546-0933

Page 1 of 15 WWW.HAULERRACKS.COM


Package Contents:

HARDWARE KIT
(8) 3/8”-16 x 3” CARRAIGE BOLTS
(20) 3/8”-16 x 2” CARRAIGE BOLTS
(4) 3/8”-16 x 1-3/4” CARRAIGE BOLTS
(4) 3/8”-16 x 1-1/2” HEX BOLTS
(12) 3/8”-16 x 1-1/4” HEX BOLTS
(44) 3/8”-16 NUTS
(44) 3/8” SPLIT LOCK WASHERS

PARTS

(1) RAIL DRIVER’S (LEFT) SIDE ASSEMBLY
(1) RAIL PASSENGER’S (RIGHT) SIDE ASSEMBLY
(1) FRONT RECTANGLULAR CROSSBAR
(1) MIDDLE CROSSBAR ASSEMBLY WITH ‘H’ & ‘T’ BRACKETS
(1) REAR CROSSBAR WITH ‘T’ BRACKETS
(4) LEGS WITH SERVICE BODY ‘C’ FEET
(4) HD BRACES
(2) SERIES 2000 PANELS (EX RACKS ONLY)

Before you begin:

Remove all components from the shipping carton.

The rack should be assembled on a padded surface such as carpet to prevent scratching of aluminum surfaces. Remove bands
securing components together.

Read the instructions thoroughly to familiarize yourself with the assembly sequence.

Note that you DO NOT tighten any nuts and bolts until the completed rack is installed on the vehicle unless specified. This allows for
minor adjustments to the rack during the installation process.

Gather the following tools used to assemble and install the rack.

1/2” & 9/16” Sockets or open end wrenches
5/16” & 3/8” Drill bits and drill
Pencil or marker
Tape measure
Center punch and hammer (optional)
Level (optional)
2 Clamps (optional)
Boards (optional)

Advertising