RECON LED Tail Lights to factory harnesses - Manual

HOW TO CONNECT THE WIRING HARNESSES ON RECON LED TAIL LIGHTS
Prior to the installation of your RECON LED tail lights, please follow the instructions below to prevent a short
circuit situation in your vehicles electrical system which will cause fuses to blow on your fuse panel.
(a) Install the function of Brake/Position light:
Please follow the directions and color of the wires (shown in Pic. 1). Connect the connector with the
corresponding wire color. (black wire goes in-line with black wire)
Pic. 1. The wire harness for the Brake/Running Light Function
(b) Install the function of Turn signal light:
Please follow the directions and color of the wires (shown in Pic. 2). Connect the connector with the
corresponding wire color. (black wire goes in-line with black wire)
Pic. 2. The wire harness for the Turn Signal Function
Remarks: If you insert the harness in the wrong direction, the light will not function properly and can blow the fuse
when tested. In this case simply replace the blown fuse and insert the harness correctly as described above in the
instructions.
If you have any questions, feel free to contact us:
[email protected] - www.GoRecon.com
Black wires
Black wires
Black wires
Black wires
From tail light From the vehicle
From the light From the car