Salamander Designs Synergy System SU40RMC/B - Manual

12x
(300-485)
1/2” Button Head
Screw
2x
(301-360)
Mounting Screw
8x
(300-560) - Flat Nut
1x
5/32” Hex Key - (400-080)
1x
1/8” Hex Key - (400-070)
Limited Warranty
For five full years Salamander Designs Ltd. will repair or
replace, at our option, any product defective in materials
or craftsmanship. Salamander Designs Ltd. will not be
responsible for any damage to or destruction of other
equipment consequential to our equipment failure. Defective
product must be given Return Authorization and is to be
returned to the factory prepaid, in the original carton and
packing material. Any damage incurred in a shipment not
in original packaging shall be the responsibility of the owner.
Warranty repairs will be returned prepaid, via UPS within
the continental U.S.A. only.
www.SalamanderDesigns.com
800-535-5659
Doc No. 500-455 / v11.10 ©2010 Salamander Designs Ltd.
SYNERGY
RACK MOUNT
300-518
300-520
OPTION: INSTALLING GEAR FORWARD
Rack rails may also be installed with the flange forward in
applications the door is not desired and additional cabinet
depth is needed.
A. Place the 1/2” Button Head Screw (300-485) in the
holes of rack mount rail and hinge bracket and loosely
screw to Flat-nut (300-560).
Note: Rackmount brackets that have a triangle
must locate at the top.
B. Slide Rack Mount Rail into position with the Flat Nuts
sliding into the channel as shown. After bracket is in
position tighten all screws with hex key.
C. Snap door onto hinge bases align top and
bottom gap and tighten.
For 15 and 21U rails:
D. Install header panel at the top same
location of rack mount.
KIT TO ACCOMMODATE DOOR