Salamander Designs CL/PM/B - Manual

2.
Install Brackets
A. Loosely assembly hardware as shown.
B. Slide flat nut on the short side of the “L” bracket
down the vertical posts (2 down each post).
3.
Re-assemble
Re-assemble horizontal post, top and rear panels.
4.
Secure Brackets
Secure one bracket at the top and secure one at the bottom of both
vertical posts. Note the positions of the brackets in the drawing.
D. Twist nut on leveler foot to the bottom of the foot. At the end of each
post screw the leveler foot into the end. Note: Screw the leveler on the
side with the Large Channel.
5.
Install Posts
A. Loosely assemble 3/8’’ length screw with a flat nut in “L” Brackets.
B. Install by sliding posts into flat nuts in the large side channel of the posts.
C. Secure in place after feet are installed (D).
6.
Install Black Panel
A. Peel plastic coat off the front of the panel.
B. Loosely assemble 3/4’’ length screw with flat nut as shown (2x).
C. Install black panel by sliding the panel with flat nuts down the front
post channels then secure in place.
7.
Install Large Bracket
A. Locate Large Bracket in PM-300 box. Loosely install hardware through
indicated holes (3/8’’ length screws and flat nuts).
B. Install Large Bracket by sliding flat nuts down the front post channels,
following the black panel. Secure at desired position.
8.
PM-300 Instructions
Continue on to the instructions included in the box labeled PM300.
Note: Step 3 of the PM-300 instructions do not apply to your Chameleon product.
1.
Disassemble
A. Remove rear panels.
B. Disassemble top from frame using 5/32” hex key.
C. Disassemble horizontal post using 1/4’’ hex key.
Large channel
9.
Wire Management
After installing your components, gather wires/cables
and attach wire managers by clipping in post channels.
chameleon TV Mount
ASSEMBLY INSTRUCTIONS
(TRIPLE WIDTH CABINETS)
3/8’’ Screw
Top
Large Side Channel Small Side Channel
Leveler Foot
Backside of Cabinet
Flat nut
(300-520)
3/4’’ Screw
(300-585)
3/8” Screw
(300-518)
Horizontal Post
Long Side
D