SecurityMan Air-Alarm - Quick Start Guide - Manual

Air-Alarm - D.I.Y Home Alarm System Kit
Quick Start Guide
Types of Defense Lines:
1 st Defense Line defends the perimeter area of homes such as doors & windows (i.e. Magnet Door Sensors).
2 nd Defense Line defends living spaces, bedrooms, & hallways areas (i.e. PIR Motion Sensors).
24Hr Defense Line defends & monitors 24hrs areas (ie. Emergency Panic Buttons, Smoke Detectors).
Using Air-Alarm:
i) Check the Wireless Magnetic Door/Window Sensor & Wireless Wide Angle PIR Motion Sensor to ensure batteries is installed
properly.
ii) Turn on the PIR sensor and face it toward an area where there are no movement to avoid faults alarm.
iii) Place the magnetic/emitting sensor close to each other within 10mm to avoid faults alarm.
iv) Plug in the Indoor Siren to an electrical wall outlet.
v) Locate a telephone LAND line and plug it into the TEL IN of the Alarm Host (SM-8088E).
vi) Plug in the A/C to the Alarm Host and turn the power switch to the ON/DC position.
vii) Press the AWAY button on the Remote Controllers to ARM. Done!
*** Any movements in front of the Wireless Wide Angle PIR Sensor will trigger the alarm. If the magnetic and the
emitting sensor of the Wireless Magnetic Door/Windows Sensor spreads beyond parameter will trigger the alarm. Upon
alarm trigger the Host and Indoor Siren will sound off the alarm and at the same time the Alarm Host will auto dial out to
the enlisted telephone number (reference pg4 of the user’s manual to add enlisted telephone numbers)
*** If sensing devices does not trigger the Alarm Host, please refer to the “To Add” instructions on the user’s manual to
add wireless devices accordingly.
INSTALLATION
Alarm Host (SM-8088E):
Find a location to install the Alarm Host, recommend flat surface near an electricity outlet and LAND line.
Level off the Anchor Card and secure the two 25mm screws through the card into the wall (use dry wall anchor for dry wall). Hook and secure
the Air-Alarm host onto the anchor screws as illustrated below.
Wireless Magnetic Door/Window Sensor (SM-87B):
Find a suitable location for the sensor near a window or door entrance or exit. Mount the magnet & emitting sensor onto doors or windows at
least 5~6ft above the ground level and less than 10mm gap in between the magnetic & emitting sensor as illustrated below.
Mount with the adhesive stickers or 13mm screws and/or use mounting bracket (25mm screws). (Reference pages 9~10 in user’s manual for
detail)
SecurityMan Inc. 1