SKC 223-Series PowerFlex - Five-station - Manual

PowerFlex Battery Charging System
Small and lightweight, the SKC PowerFlex ® is an advanced charging system
designed for optimal charging of NiCad and NiMH batt ery packs for most SKC
personal air sampling pumps. Batt eries for up to four diff erent pump models
(excluding EX and ATEX models and models with lithium-ion [Li-Ion] batt eries)
can be charged simultaneously on the fi ve-station PowerFlex.
Pump-specifi c cables are used to connect batt ery packs to the PowerFlex so that
only one charger is needed for most SKC personal sample pumps. PowerFlex fully
charges batt ery packs in 6 to 8.5 hours, and then automatically switches to a safe
pulse trickle charge. Each att ached batt ery pack runs through an independent
cycle. An LED at each port indicates batt ery charge status. Batt ery packs can be
charged att ached to or detached from the pump.
Performance Profi le*
Dimensions: 4.4 x 5.5 x 1.4 in (11.1 x 14 x 3.5 cm)
Weight: 1.1 lbs (0.5 kg)
Charging time ‡ : 6 to 8.5 hrs
Status LED: Steady Red = Charging
Steady Green = Trickle charge
Input voltage: 100-240 V
Intrinsic safety: Not intended for use in explosive or hazardous
locations
Approvals: Power supply is for electrical safety and
is CE marked.
* For U.S.-produced pump models only. Not compatible with Ex or ATEX-approved models.
‡ Typical charging times vary with model, batt ery capacity, and level of discharge.
Operating Instructions
863 Valley View Road, Eighty Four, PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]