SKC 225-1 Cassette_Cyclone Holder - Manual

Cassette/Cyclone Holder
Catalog No. 225-1
Operating Instructions
863 Valley View Road, Eighty Four, PA 15330 USA
Tel: 724-941-9701 Fax: 724-941-1369 e-mail: [email protected]
www.skcinc.com
Form # 3718 Rev 1201
Operation
Inserting 2- or 3-piece 37-mm Cassett e without Cyclone
Pull back spring-loaded hold-down plate and place loaded
cassett e inlet side down over the large hole. Position small
hole in plate over cassett e outlet. Insert adapter on rubber
tubing through the hold-down plate and into cassett e outlet.
Inserting Cassett e with Cyclone (25- and 37-mm Cassett es
assembled with cyclone)
Insert stem of cyclone through large hole in holder and secure
cassett e as described above. Insert the small round nodule on
the cyclone rim into the notch in the fi lter cassett e holder.
Inserting 2- or 3-piece 25-mm Cassett e without Cowl
Insert cassett e into supplied O-ring and position O-ring at the
joint between cassett e sections. Position cassett e in holder as
described above.
Inserting 25-mm Cassett e with Cowl (Asbestos Cassett e)
Remove inlet section. Insert cowl into supplied O-ring and
position O-ring at the joint between cassett e and cowl. Insert
cowl through large hole in holder until the O-ring contacts the
holder. Att ach cassett e to holder as described above.
SKC Limited Warranty and Return Policy
SKC products are subject to the SKC Limited Warranty and Return Policy, which provides
SKC’s sole liability and the buyer’s exclusive remedy. To view the complete SKC Limited
Warranty and Return Policy, go to htt p://www.skcinc.com/warranty.asp.
Collar
Clip
Hold-down
Plate
Adapter
for
Cassett e
Outlet
Hole for
Cassett e
Outlet
Hole for
Cassett e Inlet
and Cyclone
Notch for
Cyclone