American International Electric SEG-M - Manual (Page 6)

3.3 Connecting the SEG-1 to HC500P (RS-232)
Two different methods to can be used to connect Port A of the HC500P to the SEG-1
1. Connect to the RS232 modular jack (front of SEG-1)
2. Connect to the RS232 terminals (rear of SEG-1)
NOTE: If connection to SEG-1 is NOT located at the HC500P then the connection must be made via stranded/shielded cable.
3.3.1 SEG-1 to HC500P Connection Method 1
The diagram below illustrates the method to connect the HC500P to the RS232 port of the SEG-1 via its RS232
modular jack on the front of the unit.
3.3.2 SEG-1 to HC500P Connection Method 2
The diagram below illustrates the connections between the HC500P and the RS232 port of the SEG-1
via the terminal block at the rear of the SEG-1.
NOTE: The use of stranded shielded cable used in this diagram below is necessary when connecting
the SEG-1 at a distance from the controller.
Page 6 of 34 Document Number: 6066005, Rev 3.2