Harrington Hoists and Cranes Series 3 End Truck User Manual
Page 7
It is the responsibility of the owner/user to install, inspect, test, maintain, and operate the equipment
covered by this manual in accordance with the applicable ANSI/ASME B30 volume(s) and OSHA
Regulations.
It is the responsibility of the owner/user to have all personnel that will install, inspect, test, maintain, and
operate the equipment covered by this manual read the contents of this manual and applicable portions of
ANSI/ASME B30 volume(s), and OSHA Regulations.
If the owner/user of the equipment covered by this manual requires additional information, or if any
information in the manual is not clear, contact Harrington or the distributor of the end truck. Do not install,
inspect, test, maintain, or operate this equipment unless this information is fully understood.
A regular schedule of inspection of the equipment in accordance with the requirements of ANSI/ASME
B30 volume(s) should be established and records maintained.
Responsibility for cranes using Harrington Series 3 End Trucks:
• For cranes where HARRINGTON fabricates the bridge, Harrington is responsible for
the design of the crane based on information supplied by the customer at the time of
order.
• For cranes where OTHERS fabricate the bridge, the customer or fabricator is
responsible for the design of the crane.
1.2
Warning Tags and Labels
The End Trucks covered by this owner's manual may be used as part of a lifting system such as a crane. It is the
responsibility of the supplier and the owner of such a lifting system to provide for and ensure that the lifting
system be equipped with warning labels in accordance with applicable industry standards.
1.3
Conformance Statement
In order to meet requirements of the Crane Manufacturers Association of America (CMAA), the National
Electric Code (NEC) and the American National Standards Institute (ANSI/ASME) Harrington components
include:
• Thermal motor protection for all motors.
• Rubber bumpers
• Rubber bumpers and drop stops for motorized trolley hoists.
• Hoists load tested to 125% of rated capacity.
• Drop stops for all end trucks
• Rail sweeps for all end trucks
• Recommended bridge beams comply with CMAA.
7