APC NetBotz Room Monitor 355 NBWL0355 - Manual (Page 9)

NetBotz 355 Installation and Quick Configuration Manual 5
Rear
Item Description
 Sensor ports (4) Used for connecting APC sensors, third-party dry-contact sensors, and
standard third-party 0-5 V sensors. Third-party dry-contact state sensors
require the NetBotz Dry Contact Cable (NBES0304). Standard
third-party 0-5 V sensors require the NetBotz 0-5 V Sensor Cable
(NBES0305).
 10/100 Base-T
network port Provides for a 10/100 Base-T network connection and power through
Power-over-Ethernet (PoE). (The appliance operates at 100 Base-T only.)
Status and link LEDs indicate network traffic:
• Status LED—blinks orange and green at start-up; indicates the status of
the network connection (solid green—IP address established; blinking
green—attempting to obtain an IP address).
• Link LED—blinks to indicate network traffic (green—connected at 10
Mbps; orange—connected at 100 Mbps).
 USB port Used to configure the appliance.
 Reset Used to restart the appliance.