LA STEELCRAFT FGS-24-KD - Manual

NOTE: SPECIFICATIONS ARE SUBJECT TO CHANGE
SHEET
DATE: 7/16/12 DO NOT SCALE DRAWING
STEELCRAFT PRODUCTS
DRAWN BY: AFS
PHN 626-798-7401 FAX 626-798-1482
MODEL
P.O. Box 90365 - Pasadena, CA 91109
1 of 1
SOCCER GOAL
2
4
5
3
1
6
1
7
8
FGS-24KD
FGS-24-KD SOCCER GOAL
ITEM QTY. PART NO. DESCRIPTION
1 2 F04SG241 HORIZ - 2-3/8" OD X 24'-0" w/ CENTER STUB
2 2 F04SG242 VERT - 1-7/8" OD X 8'-0" (RIGHT AND LEFT)
3 1 F04SG243 BACK HORIZ - 2-3/8" OD X 24'-0" w/ 2 CENTER STUBS
4 2 F04SG244 BOTTOM SIDE - 1-7/8" OD X 10'-2 1/2"
5 2 F04SG245 BACK ANGLE - 1-7/8" OD X 10'-0"
6 1 F04SG246 BACK CENTER - 1-7/8" OD X 9'-9 1/2"
7 1 F04SG247 CENTER TOP - 1-7/8" OD X 3'-10"
8 2 F04SG248 SIDE TOP - 1-7/8" OD X 4'-0 1/2"
9 4 F04SG249 U ANCHOR
ASSEMBLY AND INSTALLATION INSTRUCTIONS
1. LAY FRONT CROSS BAR FACE DOWN ON THE GROUND AND SLIDE THE FRONT
VERTICAL SUPPORTS INTO THE SOCKETS. MAKE SURE THE ANCHOR RING IS ON THE
OUTSIDE OF EACH FRAME. TIGHTEN THE SET SCREWS.
2. SLIDE THE CENTER BACK SUPPORT BRACE (6) INTO THE SLEEVES WELDED TO BACK
CROSS BAR AND BOTTOM CROSS BAR. TIGHTEN THE SET SCREWS.
3. SLIDE BACK ANGLE SUPPORT INTO BACK CROSS BARS AND TIGHTEN THE SET SCREWS.
4. STAND THE FRONT AND BACK ASSEMBLIES.
5. SLIDE TOP BRACES, CENTER TOP BRACE AND BOTTOM BRACES INTO THE SLEEVES OF
FRONT AND BACK UNITS.
6. TIGHTEN ALL SET SCREWS ON THE SLEEVES.
EACH GOAL IS ANCHORED WITH TWO ½” X 18” STEEL RODS. THE RODS HAVE 3/16” CHAIN
WELDED TO THE BOTTOM OF THE TWO VERTICAL SUPPORTS.