LEDGlow Single Color Slimline Truck LED Underbody Kit - Manual

Single Color Slimline Truck Underbody Kit
Warning:
Please check your state and local laws before installing this truck LED underbody kit. Every state has different policies and
procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using this
underbody kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void
all warranties.
The power switch that is used to power the underbody tubes must be installed in a dry location! Having this part exposed to water or the
elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will void all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED
UNDERBODY KIT.
Truck Underbody Kit Includes:

(2) 48 Inch Tubes

(2) 36 Inch Tubes

(2) 24 Inch Tubes

(1) ON/OFF Switch

(16) Underbody Tube Brackets

(20) Zip Ties

(18) Large Screws

Self-Sealing Tape
Underbody Kit Installation:
1. Arrange the tubes out on the ground and test the kit to ensure proper functionality before installing.
2. Temporarily power your kit with any 12 volt source to ensure it is functioning properly before you move forward with the
installation. Simply connect the red wire to the positive terminal of the battery and the black wire to the negative terminal of the
battery or to any good ground source. Power the kit and once you have determined it is functioning properly, remove power from
the kit.
3. Before mounting the underbody tubes, please refer to the schematic below. The underbody tubes on this kit must be
installed in a specific way.
4. Once the kit is laid out and you have determined the kit is functioning properly, you can proceed with the rest of the installation.
5. Note: Each underbody tube daisy chains to the next tube with the included 6 feet of power wire and modular connectors. Use the
waterproof tape on all connectors to ensure connections are not exposed to the elements.
6. Optional: Raise and support the vehicle.
7. First, mount the front 36 inch tube to your vehicle with the male connector facing the driver’s side, using the included mounting
brackets and zip ties. Make sure the tube is at least 8 inches away from any direct heat source and away from all moving parts.
Use the included zip ties to secure the underbody tube to the mounting bracket. IMPORTANT: DO NOT MOUNT THE
TUBE TO THE RADIATOR.