LEDGlow 6pc Flexible Million Color LED Interior Lighting Kit - Manual

6pc Flexible Million Color LED Interior Kit
Warning:
Please check your state and local laws before installing this LED interior lighting kit. Every state has different policies and
procedures in place regarding aftermarket vehicle accessories. LEDGlow is not responsible for any fines that you may receive while using this
interior kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all
warranties.
The control box that is used to power the interior tubes must be installed in a dry location! Having this part exposed to water or the
elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED
INTERIOR KIT.
Interior Kit Includes:

(6) 8 Inch Tubes

(1) Control Box

(1) Wireless Remote

(14) Screws

(4) Mounting Brackets

3M Tape
Interior Kit Installation:
1. Arrange the interior tubes where you plan on installing them and temporarily power the kit to ensure proper functionality before
installing. Once you test the kit and determine it is functioning properly, disconnect the power from the kit and begin the
installation.
2. Each interior tube can be mounted virtually anywhere in your vehicle. Some good locations are under the dash in the foot well
area, under the driver and passenger seats facing the foot well area, under the back of the driver and passenger seats facing the
back seat or even in the trunk.
3. Find a safe, secure, and dry location to
mount the control box. We recommend
mounting the control box in your center
console, under the seat or in your glove
compartment by using the included screws
or 3M tape.
4. Mount the first tube to your desired
location with the included screws. If you
do not want to use the supplied screws,
you can use 3M tape, wire ties, or even
Velcro. Make sure the tube and the lead
power wire do not come in contact with
any moving parts such as, the pedals,
steering column, and/or seat tracks.
5. Mount the remaining tubes to your desired
locations in the same way you did in the
previous step. Again, be sure all tubes and
lead power wires are not in the way of any
moving parts such as the pedals, steering
column, and/or seat tracks.
6. Connect the tubes to the control box that is
already installed in a readily accessible
area free of moisture and heat.
Any damage to your kit as a result of
moisture or heat will void your
warranty.
7. Now, that your control box and tubes are
mounted, secure and hide all of the lead
wires with zip ties.