LEDGlow LiteTrike III Advanced Million Color LED Lighting Kit - Manual

LiteTrike III Advanced Million Color LED Lighting Kit
Warning: Please check your state and local laws before installing this Trike Lighting Kit. Every state has different policies and
procedures in place regarding aftermarket LED lighting accessories. LEDGlow is not responsible for any fines that you may
receive while using this lighting kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this
kit will void all warranties.
The control box that is used to power the lighting strips must be installed in a dry location! Having this part exposed to
water or the elements will cause the kit’s controller to fail. Any water damage or corrosion to this part will VOID all
warranties.
It is recommended to install each lighting strip using 3M™ Adhesion Promoter which allows for a much stronger bond between
the adhesive tape of the light strip and the cleaned mounting surface of your trike.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING
THIS LED TRIKE KIT.
LiteTrike III Kit Includes:
 (2) 36” Wheel Well Strips
 (2) 24” Strips
 (2) 18” Strips
 (2) 10.5” Strips
 (2) 8.5” Strips
 (4) 6.5” Strips
 (6) 3” Strips

(1) 6pc Power Harness

(2) 4pc Add On Harness

(3) 2pc Add On Harness

(1) Control Box

(1) Wireless Remote

(6) Packets of 3M Adhesion Promoter

Zip Ties
LiteTrike Kit Installation:
1. Upon receiving your new LiteTrike Lighting Kit, we ask that you first test the kit to ensure it is functioning properly.
Connect the red power wire from the control box to the positive terminal of the battery and the black ground wire to the
negative terminal of the battery. Once the wires are temporarily secure, power the kit by pressing “Button D” on the
wireless remote to ensure full functionality before installing it. If everything appears to be working properly, turn the
kit off and disconnect the power and ground wires from the battery to prepare for installation.
2. Optional: Remove any trim pieces from your trike that may hinder the installation of the lighting strips.
3. Begin by first laying out LED lighting strips similar to the way they will be installed. Make sure that the wires will be
able to be routed in such a way that they will not be pinched, cut or exposed to heat. Also, keep the wires and strips
away from all moving parts that may come in contact with any part of the kit. IF A POWER WIRE IS CUT OR
PINCHED, IT WILL CAUSE THE KIT TO MALFUNCTION AND WILL VOID THE WARRANTY DUE TO
PHYSICAL DAMAGE.
4. Temporarily place the lighting strips to their intended mounting locations and route the power wires to the planned
control box mounting area. Use the supplied zip ties to secure the power wires to their mounting points. Be sure to
keep the power wires away from the suspension, any direct heat sources and/or moving parts. A few
recommended locations to mount the light strips are under the running boards, under the gas tank, frame, triple trees,
dashboard, trunk, battery cover, and oil tank.
5. Once the lighting strips and wires have been mocked up, clean the proposed mounting surfaces with an alcohol prep
pad. The mounting surface should be between 45 and 85 degrees Fahrenheit to achieve the strong bonding results from