LEDGlow Advanced Million Color SMD LED Motorcycle Pod Lighting Kit - Manual

Advanced Million Color SMD Pod Motorcycle Lighting Kit
Warning: Please check your state and local laws before installing this LED Lighting Kit. Every state has different policies and
procedures in place regarding aftermarket LED lighting accessories. LEDGlow is not responsible for any fines that you may
receive while using this lighting kit. This kit is for off road use only.
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this
kit will void all warranties.
The control box that is used to power the pod lights must be installed in a dry location! Having this part exposed to water
or the elements will cause the control box to fail. Any water damage or corrosion to this part will VOID all warranties.
It is recommended to install each pod light using 3M™ Adhesion Promoter which allows for a much stronger bond between the
adhesive tape of the pod and mounting surface. This is an optional installation accessory that is NOT included with your pod
lighting kit.
PLEASE READ THE FOLLOWING INSTRUCTIONS THROUGHLY BEFORE INSTALLING AND OPERATING
THIS POD LIGHTING KIT.
Pod Lighting Kit Includes:
 Multi-Color SMD LED Pods
(Quantity Depends on Kit
Ordered)
 (1) Advanced Million Color
Control Box
 (1) 4 Button Wireless Remote

(1) 6 Piece Wire Harness

(1) 2 Piece Add On Harness
1. Upon receiving your new pod lighting kit, we ask that you first test the kit to ensure it is functioning properly.
Connect the red power wire to the positive terminal of the battery and the black ground wire to the negative
terminal of the battery. Once the wires are temporarily secure, connect the lights to the control box by using the
included harness. Power the kit on to ensure full functionality by pressing the “D” button on the included wireless
remote before installing the kit. If everything appears to be working correctly, turn the kit off and disconnect the
pod lights and power wires from the battery to prepare for installation.
2. Optional: Remove any trim pieces from your motorcycle that may hinder the installation of the pods.
3. Begin by first laying out the pod LED lights similar to the way they will be installed. Make sure that the wires will
be able to be routed in such a way that they will not be pinched, cut or exposed to heat. Also, keep the pod lights
and wires away from all moving parts that may come in contact with any part of the kit. IF A POWER WIRE IS
PINCHED, IT WILL CAUSE THE KIT TO MALFUNCTION AND WILL VOID THE WARRANTY
DUE TO PHYSICAL DAMAGE.
4. Temporarily place the motorcycle pod lights to their intended mounting locations and route the power wires to the
planned control box mounting area. Use the zip ties (not included) to secure the power wires to their mounting
points. Be sure to keep the power wires away from the suspension, any direct heat sources and/or moving
parts. A few recommended locations on your motorcycle to mount the pod lights are under the gas tank, lower
frame rail, rear fender frame rail, triple trees, lower swing arm, and under the seat.
5. Once the pod lights and wires have been mocked up, clean the proposed mounting surfaces with an alcohol prep
pad. The mounting surface should be between 45 and 85 degrees Fahrenheit to achieve the strongest bonding
results from the double sided adhesive tape. Note: The surface area must be free of all oils, moisture, dirt, and wax
in order for the supplied adhesive tape to bond and adhere to the installation surface correctly. Recommended: To
achieve the strongest bond between the pod light and the motorcycle, you can use 3M Adhesive Promoter, which
is sold separately from your kit.
6. Mount each pod light to the cleaned and dry surface of the motorcycle by using the supplied 3M tape under the
pod light. Run the wires to the planned location of the control box and secure the wire to the bike frame by using