LEDGlow Motorcycle LED Lighting Kit 4 Button Wireless Remote User Manual
LEDGlow Lighting
Effective 12/03/2013
For Full Warranty Information Vi
Motorcycle LED Lighting Kit 4 Button Wireless Remote Programming
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE PROGRAMMING THE 4 BUTTON
WIRELESS REMOTE.
Note: The following programming process can be viewed at:
4 Button Wireless Remote Programming:
1.
Disconnect the wire harness that connects your motorcycle LED lighting strips to the control box, but keep the control
box connected to your power source.
2.
After the wire harness is disconnected from the control box, remove the end cap with the lead wires to slide the circuit
board out of the control box housing.
3.
Remove the tape from around the circuit board. Once you have removed the tape from the circuit board, you need to
determine if you have control box “A” or “B”.
4.
Identifying Control Box “A” or “B”
Control Box “A” will have a white box located in the middle of the circuit board that has two silver tabs
above and below the word “key”.
Control Box “B” will have a white box located at the bottom right of the circuit board that has two silver tabs
under the word “K1”.
5.
Programming Control Box “A”
Using a flat head screw driver, simultaneously touch
both silver tabs located below the word “key” until
the LED next to it illuminates.
Once the LED is illuminated, press any button on the
new 4 button wireless remote. The LED will flash
and then turn off.
Now press the “D” button on the remote to test for
full functionality.
Cover the circuit board with the tape you removed in
Step 3 and slide the circuit board back into the
control box housing.
6.
Programming Control Box “B”
Using a flat head screw driver, touch both silver tabs
located below “K1” at the same time until the LED
next to it illuminates.
Once the LED is illuminated, press any button on the
new 4 button wireless remote. The LED will flash and
then turn off.
Now press the “D” button on the remote to test for full
functionality.
Cover the circuit board with the tape you removed in
Step 3 and slide the circuit board back into the control
box housing.
7.
Once you have programmed your new wireless remote, you can now reconnect the wire harness to the control box.
For accessories, replacement parts and/or technical support, please visit
for more information.