LEDGlow 4pc Single Color Marine LED Lighting Kit User Manual

4pc single color marine led lighting kit

Advertising
background image

4pc Single Color Marine LED Lighting Kit

Warning: We highly recommend that this Marine LED Lighting Kit is installed by a licensed professional. Any failure of this kit
due to improper installation will void all warranties.

PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING
THIS MARINE LIGHTING KIT.

4pc Single Color Marine Lighting Kit Includes:

(3) 24 Inch Waterproof
Marine Light Bars with Dual
Connectors

(1) 24 Inch Waterproof
Marine Light Bar with Single
Connector

(1) 10 Foot Power Wire

(8) Mounting Brackets

(16) Mounting Screws

Marine Lighting Kit Installation:

1.

Upon receiving your new Marine Lighting Kit, we ask that you first test the kit to ensure it is functioning properly. Be
sure to connect this kit to a 12 volt power source. Connect the included power wire to your auxiliary or accessory
power switch that is located on your boat’s console. Note: If you are connecting the power wire to an aftermarket
switch, be sure that it is connected to your boat’s breaker system.

2.

Connect the 24 inch light bar with dual connectors to the power wire using the male to female modular connections.
Connect the remaining tubes to one another by using the male to female modular connectors. Note: The 24 inch light
bar with a single connector will be the last light bar of the sequence. If everything seems to be working properly, you
can proceed with the installation and mount the light bars.

3.

Now that the light bars are connected and powered, you can mount them under the gunnels, inside of the cabin or
around the console using the included 3M™

Tape and mounting brackets. Note: The 24 inch light bar with a single

connector will be the last light bar of the sequence. If you are not installing the last tube in the sequence, be sure the
connections are not exposed to water or the elements. This could cause the kit to malfunction and will void all
warranties. Note: LEDGlow offers 3M™ Adhesion Promoter that creates an additional layer of adhesion between the
boat light bar and the mounting surface of your boat. This adhesion promoter is not required for installation but gives
added strength to the already included 3M™ Tape.

For accessories, add-on tubes, replacement parts and/or Technical Support, please visit

www.LEDGlow.com

.












Advertising