LEDGlow Commercial Lighting Kit - Manual

4pc Commercial Lighting Kit
Warning: The installation of this kit is recommended to be installed by a licensed professional. The improper installation of this kit will void all
warranties.
PLEASE READ THE FOLLOWING INSTRUCTIONS THOROUGHLY BEFORE INSTALLING AND OPERATING THIS LED
COMMERCIAL LIGHTING KIT.
Commercial Lighting Kit Includes:

(4) 40 Inch Tubes

(1) Control Box

(1) Wire Connection Driver

(1) Wireless Remote and IR Receiver

(1) Stereo Cable

(1) 110 Volt Power Supply
Commercial Lighting Kit Installation:
Depending on the location you would like to install the kit will determine the difficulty.

Can be mounted virtually anywhere with the included 3M tape.

Control Box must be mounted in a dry location.

Can be expanded to include an unlimited amount of tubes, but an additional driver and power supply are needed for every 7
tubes.
Connecting the Power Supply:
1. This kit includes a 110 volt power supply. Simply plug the kit into the power supply and then into a standard 110 volt
outlet.
2. Connect the power supply to the control box using the port designated “Power.”
Connecting the Remote Sensor:
1. Connect the red remote sensor to the port on
the control box that is designated “Remote.”
Optional: Connecting the Audio Sensor for Music
Mode:
1. This kit features a built in Music Mode that
does not require any additional installation.
2. Optional: You can hardwire this kit to your
audio system using the included audio cable.
Simply plug the audio cable into your sound
system then plug the other end into the port
designated “Audio” on the Control Box.
Installing the Tubes to the Control Box:
1. Plug the male end of the first tube into the
“Output” USB slot located on the control
box.
2. Plug the male end of the second tube into
the female end of the tube that is plugged
into the control box.
3. Repeat Step #2 until all tubes are connected
and powered.