American Power Conversion AP9619 - Manual (Page 14)

10 Installation and Quick Start
Quick Configuration
Overview You must configure the following TCP/IP settings before the
APC Network Management Card can operate on a network:
• IP address of the Management Card
• Subnet mask
• Default gateway
TCP/IP
configuration
methods Use one of the following methods to define the TCP/IP settings
needed by the Management Card:
• APC Management Card Wizard (See “APC Management
Card Wizard” on page 11 if it is supported for the
firmware release you are using.)
• BOOTP or DHCP server (See “BOOTP & DHCP
configuration” on page 12.)
• Local computer (See “Local access to the control
console” on page 15.)
• Networked computer (See “Remote access to the control
console” on page 15.)
Note
If a default gateway is unavailable, use the IP
address of a computer that is located on the
same subnet as the Management Card and that
is usually running. The Management Card uses
the default gateway to test the network when
traffic is very light.
See also
See “Watchdog Features” in the
“Introduction” of the APC Network
Management Card User’s Guide for more
information about the watchdog role of the
default gateway.