Staub Electronics ECS-200-IC-8 EPISODE - 200 COMMERCIAL SERIES IN-CEILING 25_70-VOLT SPEAKER WITH 8 IN. FULL-RANGE DRIVER (EACH) - Manual

© 2012 Episode® Rev: 121120-1606
70V - 4 Watts
25V - .5 Watts
Brown
Blue
Yellow
White
Black
Orange
Violet
Green
70V - 2 Watts
25V - na
70V - 1 Watts
25V - na
70V - .5 Watts
25V - na
Common
(GND)
70V - na
25V - 4 Watts
70V - na
25V - 2 Watts
70V - na
25V - 1 Watts
ECS-200-IC-8 Mounting Template
Tap Wattage Wire Color
0.5w White
1w Yellow
2w Blue
4w Brow n
Common Black
Tap Wattage Wire Color
0.5w Brow n
1w Green
2w Violet
4w Orange
Common Black
70v System
25v System
Security Wire Loops
Facing Up
Rev: Error! Unknown document property name.
Installation Preparation
Step 1: Us e the enclosed Tile Bridge as a template to mark the ceiling tile for cutout.
A. For a 2’ x 4’ tile, line up one of the narrow sides of the tile bridge with one of the narrow sides (2’
side) of the ceiling tile. The outer edge of the tile bridge will be at the center point of the tile, mark
this edge within the center area of the speaker.
B. Now, re-position the tile bridge so that it is perpendicular to the tile and align its center mark with the
center point of the tile you marked in (a) above.
C. The tile bridge opening is now perfectly aligned. Mark the cutout.
Step 2: Cutout the tile material for installation.
A. Using a screwdriver or other tool, perforate the ceiling tile in the 4 holes around the edge that will be
used to attach the loudspeaker.
B. Cut the speaker opening.
Tip: Place the tile over a trashcan or empty cardboard box while cutting to keep the jobsite clean.
Step 3: Install the Tile Bridge and Speaker.
A. Place the tile bridge on the bottom side of the tile
with the security loops facing up.
B. Align the ECS-200-IC-8 loudspeaker on the front,
with the mounting holes aligned for both the tile
bridge and the holes you made in the tile in step
(d) above.
C. Use the 4 enclosed screws to mount the speaker to
the tile bridge.
D. Using the two wire loops in the tile bridge, attach
security hanger wire to the assembly (not included).
Note: Local building code may require this step.
Connecting
A. Select the appropriate wattage for your installation.
B. Using the chart for either a 70v or 25v system, choose the wire color that corresponds to your desired
wattage.
C. With the amplifier turned off, use wire nuts to make the appropriate connections to the leads from
your amplifier using a) the wire chosen in Step 2 AND b) the Black (common) wire.
D. Cut off the exposed bare portion of all unused wire leads.