Steelcraft Automotive 34110 TAILLIGHT GUARD - Manual

STEELCRAFT
INSTALLATION INSTRUCTIONS
TAILLIGHT GUARD PART # T7766
2005 NISSAN FORNTIER
PARTS LIST
(1)- TAILLIGHT GUARD PASSENGER SIDE
(1)- TAILLIGHT GUARD DRIVER SIDE
(2)- SUPPORT BRACKETS
(2)- # 6 x 1/2" SCREWS, (2)- 1/4 SCREWS, (2)- 1/4 WASHERS
INSTALLING TAILLIGHT GUARD
1) START WITH THE PASSENGER SIDE, OPEN THE REAR GATE AND REMOVE THE SCREWS SECURING THE
TAIL LIGHT TO THE BODY.
2) CAREFULLY UNSNAP THE TAIL LIGHT UNTIL IT IS FREED FROM THE HOUSING.
3) ATTACH THE SUPPORT BRACKET TO THE EXISTING HOLE BY USING THE 1/4 x 3/4” SCREW, 1/4 WASHER
AND 1/4 HEX NUT.
4) SNAP THE TAIL LIGHT ASSEMBLY BACK INTO BODY.
5) POSITION REAR TAILLIGHT GUARD OVER TAIL LIGHT, MAKING SURE THAT THE MOUNTING BRACKETS
ON THE TAILLIGHT GUARD ARE SEATED WHERE THE TAIL LIGHT SCREWS WERE FORMERLY LOCATED.
6) SECURE ASSEMBLY TO JAMB USING THE EXISTING SCREWS. SUPPORT BRACKET USE THE # 6 x 1/2”
SCREWS.
7) RE-PEAT STEPS 1 THROUGH 6 ON THE DRIVER SIDE.
CUSTOMER SERVICE TOLL FREE (888) 800-ARIES