Steelcraft Automotive 32160 TAILLIGHT GUARD - Manual

STEELCRAFT
INSTALLATION INSTRUCTIONS
TAILLIGHT GUARD PART # 32160
2006 JEEP COMMANDER
PARTS LIST
(1)- TAILLIGHT GUARD PASSENGER SIDE
(1)- TAILLIGHT GUARD DRIVER SIDE
(2)- SUPPORT BRACKETS
(2)- # 6 x 1/2" SCREWS
INSTALLING TAILLIGHT GUARD
1) START WITH THE DRIVER SIDE, OPEN THE REAR LIFT GATE AND REMOVE THE PLASTIC CLIPS SECURING
THE TAIL LIGHT TO THE BODY.
2) CAREFULLY UNSNAP THE TAIL LIGHT UNTIL IT IS FREED FROM THE HOUSING.
3) REMOVE THE TOP ATTACHMENT PIN FROM THE TAIL LIGHT. POSITION THE SUPPORT BRACKET
BETWEEN THE PIN AND TAIL LIGHT (LARGER HOLE)
4) SNAP THE ASSEMBLY BACK INTO BODY.
5) POSITION TAILLIFGT GUARD OVER TAIL LIGHT, MAKING SURE THAT THE MOUNTING BRACKETS ON THE
TAILLIGHT GUARD ARE SEATED WHERE THE TAIL LIGHT PLASTIC CLIPS WERE FORMERLY LOCATED.
6) SECURE ASSEMBLY TO JAMB USING THE PLASTIC CLIPS PREVIOUSLY REMOVED, SUPPORT BRACKET USE
THE # 6 x 1/2" SCREWS.
6) RE-PEAT STEPS 1 THROUGH 6 ON THE PASSENGER SIDE.
CUSTOMER SERVICE TOLL FREE (888) 261-4537