System Sensor BEAM1224, BEAM1224S - Manual (Page 5)

fIgURE 7. wIRINg CONNECTIONS AT DETECTOR:
POWER OUT (–) POWER OUT (+) POWER IN (–
)
POWER IN (+) RESET I NPUT TEST INPU
T
AUX (–
)
REMOTE ALARM OUT Not used REMOTE TROUBLE OUT TROUBLE CO
M
TROUBLE N.C. ALARM COM ALARM N.O
.
ALARM COM ALARM N.O
.
T3 T2 T1 T4
C0271-00
WARNING: Disable the zone or system before applying power to the beam
detector to prevent unwanted alarms. When applying power to the beam de-
tector before the alignment procedure has been completed the detector may
enter alarm or trouble.
fIgURE 8. wIRINg DIAgRAM (RTS451 OR RTS151):
RTS451/KEY
or RTS151/KEY
BEAM1224
PIN 1 REMOTE ALARM OUT T2-1
T2-2
T2-4
T2-3
AUX (–)
RESET INPUT
TEST INPUT
SEE RTS451/KEY or RTS151/KEY
INSTALLATION INSTRUCTIONS
FOR ELECTRICAL RATINGS
PIN 2
PIN 4
PIN 3
PIN 5
C0273-01
fIgURE 9. wIRINg DIAgRAM (REMOTE LEDS):
T2-1
T3-3
T2-2 YELLOW
RED
BEAM1224/S
ALARM
SIGNAL
CIRCUIT
(NOTE 1)
TROUBLE
SIGNAL
CIRCUIT
(NOTE 1)
NOTE 1: SEE ELECTRICAL RATINGS SECTION OF THIS
MANUAL FOR CIRCUIT OUTPUT RATINGS.
C0319-01
INSTALLATION/ALIgNMENT
Reference Figures 10 through 14 for installation, alignment, and maintenance.
Please make sure to complete all steps in order to ensure a successful installa-
tion. Proper application, mounting, alignment, and set-up will minimize false
alarms and nuisance trouble signals.
D400-73-00 5 I56-2294-006R
fIgURE 6. wIRINg DIAgRAM:
CLASS A
RETURN
LOOP
LISTED PANEL BEAM1224 BEAM1224
T2-2
T2-1
T3-3
T2-3
T2-4 AUX (–)
REMOTE ALARM OUTPUT
REMOTE TROUBLE OUTPUT
TEST INPUT
RESET INPUT T2-2
T2-1
T3-3
T2-3
T2-4 AUX (–)
REMOTE ALARM OUTPUT
REMOTE TROUBLE OUTPUT
TEST INPUT
RESET INPUT
EOL RESIS-
TOR
NOTE: If other sensors are installed on the same loop, a listed end of line power supervision module is required.
TROUBLE
COM
TROUBLE
NC
TROUBLE
COM
TROUBLE
NC
ALARM COM ALARM COM ALARM COM ALARM COM
ALARM NO ALARM NO ALARM NO ALARM NO
POWER +
INITIATING +
INITIATING –
POWER –
POWER IN (–) POWER OUT (–)
POWER IN (+) POWER OUT (+)
POWER IN (–) POWER OUT (–)
POWER IN (+) POWER OUT (+)
T1-1
T1-2
T4-2
T4-1
T3-2
T1-3
T1-4
T4-4
T4-3
T3-1
T1-1
T1-2
T4-2
T4-1
T3-2
T1-3
T1-4
T4-4
T4-3
T3-1
C0272-01