AMD Geode LX 800@0.9W - Manual (Page 370)

370 AMD Geode™ LX Processors Data Book
Display Controller Register Descriptions 33234H
6.6.19.24 Vertical Blank Start
6.6.19.25 Vertical Blank End
6.6.19.26 CRTC Mode Control
Index 15h
Type R/W
Reset Value 00h
Vertical Blank Start Register Bit Descriptions
Bit Name Description
7:0 V_BL_ST Vertical Blank Start Register Bits [7:0]. This is the low eight bits of a value that speci-
fies the starting scan line of the vertical blank signal. This is a 10-bit value. Bit 8 is in the
Overflow register (Index 07h[3]) and bit 9 is in the Maximum Scan Line register (Index
09h[5]).
Index 16h
Type R/W
Reset Value 00h
Vertical Blank End Register Bit Descriptions
Bit Name Description
7:0 V_BL_END Vertical Blank End. This value specifies the low eight bits of a compare value that repre-
sents the scan line where the vertical blank signal goes inactive.
Index 17h
Type R/W
Reset Value 00h
CRTC Mode Control Register Bit Descriptions
Bit Name Description
7 ENSYNC Enable Syncs. When set to 1, this bit enables the horizontal and vertical sync signals.
When 0, this bit holds both sync flip-flops reset.
6 BTMD Byte Mode. If the DWORD mode bit (DW, Index 14h[6]) is 0, then this bit configures the
CRTC addresses for byte addresses when set to 1, or WORD addresses when set to 0. If
DW is set to 1, then this bit is ignored. See Table 6-55 on page 371 for information on the
various CRTC addressing modes.
5 AW Address Wrap. When the CRTC is addressing the frame buffer in Word Mode (Byte
Mode = 0, DWORD Mode = 0) then this bit determines which address bit occupies the
MA0 bit position of the address sent to the frame buffer memory. If Address Wrap = 0,
CRTC address counter bit 13 occupies the MA0 position. If Address Wrap = 1, then
CRTC address counter bit 15 is in the MA0 position. See Table 6-55 on page 371 for
information on the various CRTC addressing modes.
4 RSVD Reserved.
3 RSVD Not Implemented. (Count by 2)
2 VCKL_SL VCLK Select. This bit determines the clocking for the vertical portion of the CRTC. If this
bit is 0, the horizontal sync signal clocks the vertical section. If this bit is 1, the horizontal
sync divided by two clocks the vertical section.