AMD Geode LX 800@0.9W - Manual (Page 454)

454 AMD Geode™ LX Processors Data Book
Video Processor Register Descriptions 33234H
6.8.3.45 Power Management (PM)
19 MCS Color/Mono Select. Selects color or monochrome LCD panel.
0: Color.
1: Monochrome.
18:16 PIXF Pixel Output Format. These bits define the pixel output format. The selection of the
pixel output format determines how the pixel data is formatted before being sent on to the
DRGB pins. These settings also determine the SHFCLK frequency for the specific panel.
000: Up to 24-bit TFT panel with one pixel per clock.
SHFCLK = DOTCLK.
001: 18/24-bit TFT XGA panel with two pixels per clock.
SHFCLK = 1/2 of DOTCLK.
010, 011, 100, 101, 110, and 111: Reserved.
15:0 RSVD Reserved. These bits are not defined.
FP Memory Offset 410h
Type
R/W
Reset Value 00000000_00000002h
PT2 Bit Descriptions (Continued)
Bit Name Description
PM Register Map
63 62 61 60 59 58 57 56 55 54 53 52 51 50 49 48 47 46 45 44 43 42 41 40 39 38 37 36 35 34 33 32
RSVD
31 30 29 28 27 26 25 24 23 22 21 20 19 18 17 16 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
SP
PWR_SEQ_SE
L
PNL_PWR_SIM
D P
PUB2 PUB1 PUB0
PD2 PD1 PD0
HDEL VDEL
SINV
SP
P
A
N
E
L_PWR
_UP
P
A
NEL_PWR_D
O
W
N
PA
N
E
L
_
O
F
F
P
A
NEL_ON
PM Bit Descriptions
Bit Name Description
63:32 RSVD (RO) Reserved (Read Only). Reads back as 0.
31:28 SP Spares. Read/write; no function.
27 PWR_SEQ_SEL Power Sequence Select. Selects whether to use internal or external power
sequence. The power sequence controls the order in which VDDEN, the data and
control signals, and the backlight control signal DISPEN become active during power
up, and inactive during power down.
0: Use internal power sequencing (timing is controlled by bits [24:18]).
1: Use external power sequencing.
Must be written to 0.
26 PNL_PWR_SIM Panel Power Sequence Test Mode. This bit should always be set to 0.
For simulating the model of the panel power sequence logic, this bit may be set to 1. It
connects the 14 MHz reference clock to the 32 Hz panel power sequence clock for
faster simulations. The hardware will not function properly if this bit is set to 1.