Teledyne LeCroy TTL-AUX-OUT - Manual

Instructions
TTL-AUX-OUT Accessory
Thank you for purchasing a Teledyne LeCroy Transistor-Tran-
sistor Logic (TTL) Auxiliary Output Amplifier Adapter—referred
to as TTL-AUX-OUT. This device is meant for use on Wav-
eRunner 6 Zi and HRO 6 Zi oscilloscopes.
The TTL-AUX-OUT accessory converts your 1 V auxiliary out-
put signal to a 3 V TTL level output.
Connecting/Disconnecting the Accessory
Connect the male, ProBus end of the TTL-AUX-OUT accessory
to the AUX OUT output on your Zi oscilloscope.
The accessory should make a distinct clicking sound as it
snaps into place.
Once attached, you can use the now 3 V TTL level auxiliary out-
put signal from the female side of the TTL-AUX-OUT accessory.
Disconnect the TTL-AUX-OUT by pulling firmly on the body of
the accessory. The accessory normally makes a clicking sound
as the connection is released.
© 2013 Teledyne LeCroy, Inc. All rights reserved.
Teledyne LeCroy is a trademark of Teledyne LeCroy, Inc. Other product or brand names are trademarks or
requested trademarks of their respective holders. Information in this publication supersedes all earlier versions.
Specifications are subject to change without notice.
July 2013
922273-00 Rev A 1