Nilfisk-ALTO SW 850S B - Manual (Page 65)

ENGLISH USER MANUAL
14 146 0789 000(4)2007-03 A SW 850S B
DEBRIS CONTAINER EMPTYING
Stop the machine by releasing the drive lever (4).
Turn the ignition key (61) to "0".
Disengage the debris container hook (18) by pulling its lower end.
With the handle (19) remove the debris container (17) and empty it into an appropriate container.
Install the debris container (17) and engage the hook (18).
The machine is ready to start working again.
AFTER USING THE MACHINE
After working, before leaving the machine, perform the following procedures.
Clean the dust fi lter with the manual fi lter shaker (20) or the electrical fi lter shaker (67), if equipped.
Empty the debris container (17) (see the procedure in the previous paragraph).
Lift the side broom with the knob (12).
Remove the ignition key (61).
Make sure that the machine cannot move independently.
If equipped, press the pedal brake (26).
PUSHING THE MACHINE
The machine can be pushed both with the ignition key (61) to “0” and to “I”.
MACHINE LONG INACTIVITY
If the machine is not going to be used for more than 30 days, proceed as follows:
Check that the machine storage area is dry and clean.
Disconnect the battery connector (33).
Slightly lift the machine so that the skirts, the main broom and the wheels do not touch the ground.
If the electronic battery charger (34) is installed, disconnect the positive terminal (+) directly from the (+) pole of the batteries
(32).
FIRST PERIOD OF USE
After the fi rst 8 hours, check the machine fastening and connecting parts for proper tightening and check the visible parts for
integrity and leakage.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.
5.
6.
1.
2.
3.
4.