WolfVision VZ-15b Quick Manual - Manual

CLEANING THE MIRROR
For cleaning the mirror on the arm, wipe it gently with a soft and lint-free tissue.
Normal dry cleaning should be sufficient. If not, use a special optical cleaner only!
(DO NOT USE ORDINARY GLASS CLEANER OR ALCOHOL
- THE RESULT WOULD BE A SLIGHTLY BLUE MIRROR SURFACE) !
The glass covering the mirror inside the unit should also be kept clean.
Always keep the mirror on the arm clean !
Dust, dirt or fingerprints affect the picture quality very much!
Reflection: No reflection: No reflection:
Working plate
Light reflected directly
into camera Light reflected to
the outside Light reflected to
the outside
If this is not possbile (e.g. with very big objects), pull the working plate to the front of the unit
(as shown below) and tilt the reflector head accordingly.
REFLECTIONS / GLARE
Reflections can appear only in the bottom half of the working surface, where the light is reflected
directly into the camera. In this case, move the object upwards and tilt the reflector head slightly.
CAUTION: Sensitive front coated mirror!
Move tissue in vertical direction only! Avoid high pressure !
Reflection
free area
88 % of the working plate (the upper part) are a reflection
free area, as the light is reflected to the outside and not into
the camera. In this area reflections can only appear if the
transparencies are very wavy or if the room light causes the
reflections!
R
Important
Information
VZ-15b / VZ-35b / VZ-45b
Please make sure that reflections are not caused by room light !
CLEANING THE MIRROR
For cleaning the mirror on the arm, wipe it gently with a soft and lint-free tissue.
Normal dry cleaning should be sufficient. If not, use a special optical cleaner only!
(DO NOT USE ORDINARY GLASS CLEANER OR ALCOHOL
- THE RESULT WOULD BE A SLIGHTLY BLUE MIRROR SURFACE) !
The glass covering the mirror inside the unit should also be kept clean.
Always keep the mirror on the arm clean !
Dust, dirt or fingerprints affect the picture quality very much!
Reflection: No reflection: No reflection:
Working plate
Light reflected directly
into camera Light reflected to
the outside Light reflected to
the outside
If this is not possbile (e.g. with very big objects), pull the working plate to the front of the unit
(as shown below) and tilt the reflector head accordingly.
REFLECTIONS / GLARE
Reflections can appear only in the bottom half of the working surface, where the light is reflected
directly into the camera. In this case, move the object upwards and tilt the reflector head slightly.
CAUTION: Sensitive front coated mirror!
Move tissue in vertical direction only! Avoid high pressure !
Reflection
free area
88 % of the working plate (the upper part) are a reflection
free area, as the light is reflected to the outside and not into
the camera. In this area reflections can only appear if the
transparencies are very wavy or if the room light causes the
reflections!
R
Important
Information
VZ-15b / VZ-35b / VZ-45b
Please make sure that reflections are not caused by room light !