ACTiSYS ACT-IR3200SW - Manual (Page 20)

ACT-IR3200SW User’s Manual The Wireless Connectivity Expert
6) THE MEANING OF TEST RESULTS AND ERROR CODES
Test Result Error
Code Remark
Pass 0x00 No error.
Frame
truncated 0x01 XIR, SNRM, RR, and TEST successful. But the Test response(s)
received is (are) truncated. This is allowed according to IrLAP
Version 1.1, but the propose of sending and receiving TEST
commands/responses are not accomplished (due to this loophole in
IrLAP Version 1.1)
XID frame failed 0x99 after repeated 0-slot XID commands, IR3200M did not receive
correctly formatted XID response.
SNRM frame
failed 0x89 XID successful, SNRM sent, IR3200M did not receive correctly
formatted UA response.
RR frame failed 0x79 XID and SNRM successful, IR3200M received UA response
indication that the intended data rate is supported and set to this
data rate. But after IR3200M repeated sending RR commands at
that data rate, IR3200M did not receive correctly formatted
response.
Rate not
supported 0x81 XID and SNRM successful, IR3200M received UA response
indicating that the intended data rate to be tested is not supported.
First test frame
failed 0x09 XIR, SNRM, and RR successful, but IR3200M never received any
correctly formatted Test frame response.
Test frame
failed 0x02 IR3200M will disconnect the connection and quit the current test
item if it failed to get correct response to anyone of its test frames.
This error means that XIR, SNRM, RR, and at least one TEST
successful there after.
Pass = no any bit error happened with this cycle.
Failed = any error happened with this cycle.
Error Rate = failed Cycles / Cycles tested
7) PHYSICAL LAYER TEST
Check the frame encoding/decoding (Byte stuffing of SIR, Bit-stuffing of MIR or 4 PPM
encoding/decoding).
Receiver sensitivity test.
To socialite frames from the secondary device for measuring its physical layer
parameters, such as transmitter intensity, timing parameters.
8) IRLAP TEST
Check the basic IrLAP layer implement, such as Discovery (XID), Negotiate (SNRM),
Data sending / receiving at different speed (FIR/MIR/SIR), FCS (Frame Check
Sequence) implements, speed support and changing and etc.
 Copyright 2004-2005 ACTiSYS Corp. Page
20 of 24 July 12 th , 2005
Version 1.2