AmpliVox TABLETOP LECTERN W/S-250 - Manual

Packing List:
Reading table top
Bottom panel
2 Side panels, left and right
Front/speaker panel
Black speaker grille(S-250)
Hand-held mic (S-250)
Mic cable (S-250)
Gooseneck w/mic holder (S-250)
Amplifier (S-250)
Easy Step-By-Step Instructions
Featuring Quickfit-Expando-6 Connectors
for W/S-250 Tabletop Lectern Assembly
The Tabletop Lectern is designed
for easy assembly. If you have any
questions about assembling or using
your new sound system, or if you want
more information about accessories,
call AmpliVox s customer
service line.
The lectern is carefully packed
to minimize shipping damage. If your
unit was damaged in shipping call our
toll-free customer service line or visit
our web site at http://www.ampli.com
1-800-267-5486
Reading
Table Top Panel
Bottom
Left Side
Right Side
How the Quickfit-Expando-6 Connectors
work.
Do not over tighten the connectors.
They will break if turned too far.
Turn only
1/2 turn clockwise to lock. The steel
Quickfit-6 expanding dowels and the
Quickfit-Expando-6-Connectors lock
together for easy assembly.
3. Inspect the Pre-installed Quickfit
Expando-6 Connectors. Check the Top,
Speaker/Front, Left and Right Side
Panels to insure that the flat edge on the
connector is facing the outer edge of the
board. Use a phillips screwdriver to rotate
them, if needed.
Untightened
(unlocked)
To tighten
(to lock)
Edge of board
Edge of board
To untighten
(to unlock)
Tightened
(locked)
1. Unpack all the pieces. Be sure to
save the packing and the box in case
you need to return the lectern for any
reason. Check that you have all the
pieces and that they are not damaged.
2. Insert the dowel pins. W ith your
thumb(or use phillips screwdriver to
ease insertion), push the dowel pins
into the holes in the 2 sides and the top.
Make sure the plastic collar is flush with
the wood surface.
Speaker/
Front
Panel
F:\docs\productinstructions\r-
Quickfit-6 Expanding Dowel Pin
Hardware:
12 Quickfit-Expando-6 Connectors
pre-installed
12 Push-in Quickfit-6 Expanding dowels
Tools Needed:
Phillips Screwdriver - for 1/2 turn of pre-
inserted Quickfit-Expando-6 Connectors
The Titus fittings sup-
kit have been specially
for ease of
Turn counterclockwise to unlock