Otter Outdoors XT650 Bench Seat - Manual

Otter Wild Bench Instructions
Note: Installing bench before attaching the fish house will make the
installation much easier.
Parts included:
Tools required:
Drill
9/32 drill bit
7/16 wrench and socket and ratchet
½ wrench and socket and ratchet
Phillips screwdriver
1. Layout all parts. Turn bench over so the bottom is facing upward and the hinges are
facing away from you. Place the curved support bar with the two holes near the end on
the bench. On the left side, line up the edge of the seat with the inside edge of the tube.
Place the tube clamp bracket over the bar and attach with the Phillips head machine
screws by threading them into the inserts in the bottom of the bench. Attach brackets in
two places on the support bar.
Hinge
Line up inside edge of the
tube with the edge of the seat.
Hole near end
Inserts in bench