Probuilt Professional Lighting Wobblelight Super Duty - Manual

Manufactured by ProBuilt Professional Lighting: 877-707-0800
Thank you for purchasing Wobblelight ® Super Duty
IMPORTANT SAFETY INSTRUCTIONS
WARNING !!!
READ AND UNDERSTAND ALL INSTRUCTIONS
Failure to follow all instructions listed below may result in electric shock, fire and/or serious injury.
SAVE THESE INSTRUCTIONS
This manual contains important safety and operating instructions for Wobblelight
® Super Duty portable job site lighting. Before using Wobblelight ® Super Duty,
please review all of the following safety instructions carefully and read all labels on the Wobblelight ® Super Duty unit.
INSTRUCTIONS PERTAINING TO THE RISK OF FIRE, ELECTRIC SHOCK, EXPOSURE TO UV RADIATION AND INJURY TO PERSONS:
WARNING: To reduce the risk of fire, electric shock, exposure to excessive UV radiation or injury to persons:
 DO NOT connect Wobblelight ® to power source until the bulb is installed and the unit is completely assembled.
 Metal halide bulbs get EXTREMELY HOT immediately upon illumination and can cause burns.
 Bulbs stay hot for an extended period of time after Wobblelight ® unit has been turned off, and can continue to cause burns.
 DO NOT attempt to remove the protective lens to change bulbs unless the Wobblelight ® unit is disconnected from the power source and the bulb has
completely cooled.
 Not for use in wet locations. DO NOT use Wobblelight ® where this is potential for exposure to excessive moisture from rain, snow, ice, water spray or
standing water.
 Connect
Wobblelight ® only to 120 volt, 60 Hz power source which is protected with a ground-fault circuit interrupter (GFCI) and over-current protection
which is rated no higher than 20 amps. Any other connection voids warranty.
 Keep away from flammable materials.
 Wobblelight ® must be operated in the upright position only. DO NOT mount Wobblelight ® units upside down or restrain them such that they lay on their
side.

DO NOT lift, hoist or suspend Wobblelight ® above people or work areas.
 Use only approved extension cords in good condition and of the appropriate type, gauge and length. To connect Wobblelight ® units to a power source and
to each other, it is recommended to use 3-wire, 10-gauge extension cords that do not exceed 25 feet in length.
 Keep extensions cords dry and use ground fault circuit interrupter (GCFI) devices in accordance with all applicable electrical code requirements.