AudioSource Amp Seven T - Manual

midpoint and use your signal source (receiver, CD player, preamplifier, etc.) to adjust the volume.
Stereo Power Amplifier with Internal Bridging
We hope that you will enjoy your AudioSource Amp Seven T. Please take a few moments to read this manual, and be sure
to retain this document for future re f e rence. Note: If any part of this product is damaged or missing, do not contact your
A u d i o S o u rce dealer. Please call us directly at 800-435-7115.
Owner’s Manual
Using the Controls/Front Panel
Power
This front panel button will manually switch the Amp Seven T on or off. A multicolored LED indicates its power status. To use the
Auto On feature, leave this front panel switch in the on position.
Speaker Selector
The Amp Seven T has two pairs of speaker outputs. Press button A to activate the A outputs. Press button B to activate the B outputs.
Both A and B outputs may be used simultaneously, provided the combined impedance does not fall below 2 ohms. Before pressing
either of the speaker selector buttons, be sure that the level controls are set at the minimum position.
Input Level Controls
These knobs adjust the incoming signal level and thereby act as volume controls. We recommend that you set these at
Amp Seven T