SaltDogg TGS07YEL Salt Spreader - Manual

1
TM
9049 Tyler Blvd. • Mentor, Ohio 44060
Phone (440) 974-8888 • Fax (440) 974-0165
Toll-Free Fax 800-841-8003 • saltdogg.com
Installation Instructions
TGS07 Salt Spreader
TGS07RED Salt Spreader
TGS07YEL Salt Spreader
Serial Number 01700 and Higher
—continued inside
WARNING
Observe the following Safety Precautions before,
during and after operating this spreader. By following
these precautions and common sense, possible injury
to persons and potential damage to this machine may be
avoided.
SPREADER WARRANTY
This warranty replaces all previous warranties and
no employee of this company is authorized to extend
additional warranties, or agreements, or implications
not explicitly covered herein.
Buyers Products Company warrants all parts of
the product to be free from defects in material and
workmanship for a period of one (1) year. Parts must be
properly installed and used under normal conditions.
Normal wear is excluded.
Any part, which has been altered, including
modifications, misuse, accident, or lack of maintenance
will not be considered under this warranty.
The sole responsibility of Buyers Products Company
under this warranty is limited to repairing or replacing
any part(s), which are returned, prepaid, 30 days after
such defect is discovered, and returned part(s) are
found to be defective by Buyers Products Company.
Authorization from Buyers Products Company must
be obtained before returning any part. The following
information must accompany defective parts returned
to Buyers Products Company: RMA #, spreader model,
serial number, date installed, and distributor from
whom purchased.
Buyers Products Company shall not be liable for
damage arising out of failure of any unit to operate
properly, or failure, or delay in work, or for any
consequential damages. No charges for transportation
or labor performed on any part will be allowed under
this warranty.
Safety Precautions
1. Read this entire Installation Instruction before
operating this spreader.
2. Read all safety decals on the spreader before
operating.
3. Verify that all personnel are clear of the
spreader spray area before starting or operating this
spreader.
4. Do not adjust, clean, lubricate or unclog material
jams without first turning off the spreader.
5. Make sure the spreader is securely fastened to
the vehicle in accordance with this manual.
6. Do not operate a spreader that is in need of main-
tenance or repairs.
7. Always disconnect the battery before removing or
replacing electrical components.
Spreader Assembly
Check contents of box against parts list to make
sure all components are included. When ordering
replacement or spare parts refer to parts list for part
numbers.