Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 11)

11
(2) Pass the band of the USB cable clamp
through the bridge of the USB holder.
(3) Insert the USB cable into the port.
Fasten the band around the plug and
secure it with the clamp.
„ Removing the USB Cable Clamp
(1) Lower the tab and lift the clamp to
release the plug.
UL/c-UL Approval
The AGP3300-U1-D24 unit is a UL/c-UL
listed product.
(UL File No.E220851)
These products conform to the following
standards:
• UL508
Industrial Control Equipment
• CSA-C22.2 No.142-M1987 (c-UL Approval)
Process Control Equipment
<Cautions>
Be aware of the following items when
building the GP into an end-use product:
• The GP unit’s rear face is not approved as
an enclosure. When building the GP unit
into an end-use product, be sure to use an
enclosure that satisfies standards as the
end-use product’s overall enclosure.
• The GP unit must be used indoors only.
• Install and operate the GP with its front
panel facing outwards.
• If the GP is mounted so as to cool itself
naturally, be sure to install it in a
vertical panel. Also, it’s recommended
that the GP should be mounted at least
100mm away from any other adjacent
structures or machine parts. The
temperature must be checked on the
final product in which the GP is
installed.
• For use on a flat surface of a Type 1
Enclosure.
USB Holder
Bridge
USB Holder
Clamp
USB Cable
Tab
Clamp
Product Model No.
UL/c-UL Registration
Model No.
AGP3300-U1-D24 3710015-01