Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 8)

8
(3) The following figures show the four
(4) fastener insertion slot locations.
Insert each fastener’s hook into the
slot and tighten it with a screwdriver.
Insert the installation fasteners
securely into the insertion slot
recess.
• Tightening the screws with too much force
can damage the GP unit’s plastic case.
• The necessary torque is 0.5N
•m.
Wiring
• To avoid an electric shock, prior to con-
necting the GP unit’s power cord termi-
nals to the power terminal block,
confirm that the GP unit’s power supply
is completely turned OFF, via a
breaker, or similar unit.
• Any other power level can damage
both the GP and the power supply.
• When the FG terminal is connected, be
sure the wire is grounded.
1. Wiring the DC Type Power Cord
„ Power Cord Specifications
Use copper conductors only.
„ Power Connector (Plug) Specifications
Top
Insertion Slots
Bottom
Insertion Slot Recess
Hook the fastener on the
Recess,
Panel
Installation Fastener
GP
Hook
and secure the fastener
on the panel with a
screwdriver.
Power Cord
Diameter 0.75 to 2.5mm 2
(18 - 12AWG)
Conductor
Type
Simple or Stranded Wire
*1
*1 If the Conductor’s end (individual) wires are not
twisted correctly, the end wires may either short
against each other, or against an electrode.
Conductor
Length
+ 24V
- 0V
FG
Grounding
Terminal
connected
to the GP
chassis
7mm
[0.28in]
Insertion
Direction
+
-
FG