Proface AGP3500 - 10.4 DIO HMI" - Manual (Page 9)

9
• The power connector (plug) is CA5-
DCCNM-01 made by Pro-face or
MSTB2,5/3-ST-5,08 made by Phoenix
Contact.
When connecting the Power Cord, use the
following items when performing wiring:
(Items are made by Phoenix Contact.)
„ Connecting the GP Power Cord
(1) Confirm that the GP unit’s Power
Cord is unplugged from the power
supply.
(2) Remove the power connector (plug)
from the right side of the main unit.
(3) Strip the power cord, twist the
conductor’s wire ends, insert them
into the pin terminal and crimp the
terminal. Attach the terminal to the
power connector.
• Use a flat-blade screwdriver (Size 0.6
X 3.5) to tighten the terminal screws.
The torque required to tighten these
screws is 0.5 to 0.6N
•m [5-7Lb•In.].
• Do not solder the cable connection.
Doing so may damage the unit due to
abnormal heat or cause a fire.
(4) Attach the Power connector (Plug) to
the GP.
2. Power Supply Cautions
• Input and Output signal lines must be
separated from the power control
cables for operational circuits.
• To improve noise resistance, be sure to
twist the ends of the power cord wires
before connecting them to the Power
connector (Plug).
• The GP unit’s power supply cord should
not be bundled with or kept close to main
circuit lines (high voltage, high current),
or input/output signal lines.
• To reduce noise, make the power cord
as short as possible.
• If the supplied voltage exceeds the GP
unit’s range, connect a voltage trans-
former.
• Be sure to use a low noise power
supply between the line and the
ground. If there is an excess amount of
noise, connect a noise reducing
transformer.
• The temperature rating of field installed
conductors: 75
o
C only.
• Use voltage and noise reducing
transformers with capacities exceeding
Power Consumption value.
• Must be used with a Class 2 Power
Supply. (24VDC)
Recomended
Driver SZF 1-0.6x3.5
(1204517)
Recomended
Pin Terminals
AI 0.75-8GY (3200519)
AI 1-8RD (3200030)
AI 1.5-8BK (3200043)
AI 2.5-8BU (3200522)
Recomended
Pin Terminal
Crimp Tool
CRIMPFOX ZA 3
(1201882)
Power Connector (Socket)
Power connector (Plug)
FG
+
-