Relevant standards, Relevant products, Danger – Proface AGP3500 - 10.4 DIO HMI" User Manual
Page 3
3/10
Relevant Standards
These devices have been manufactured in accordance with:
•
Standard EN 60079-0 (2009) and IEC 60079-0 Ed6 (2011): Explosive
atmospheres - Part 0: Equipment - General requirements.
•
Standard EN 60079-15 (2010) and IEC 60079-15 Ed4 (2010): Explosive
atmospheres - Part 15: Equipment protection by type of protection “n”.
•
Standard EN 60079-31 (2009) and IEC 60079-31 Ed1 (2008): Explosive
atmospheres - Part 31: Equipment dust ignition protection by enclosure
“t”.
Relevant products
These recommendations relate to graphic panels intended for installation in
areas where explosive atmospheres may occur (Zones 2/22) for Category 3G
or 3D equipment (Category 3: normal level of protection - G: Gas - D: Dust).
DANGER
POTENTIAL FOR EXPLOSION
Install, use, and maintain these modules in accordance with:
•
Standard IEC 60079-14 Ed4 (2007): Explosive atmospheres - Part 14:
Electrical installations design, selection and erection.
•
Standard EN 60079-17 (2007): Inspection and maintenance of
electrical installations in hazardous areas.
•
Standard EN 61241-14 (2004): Electrical apparatus for use in the
presence of combustible dust, Part 14: Electrical apparatus protected
by enclosures. Selection, installation and maintenance.
•
Edicts, by-laws, laws, directives, circulars, standards, regulations and
any other document relating to where the apparatus is installed.
Failure to follow these instructions will result in death or serious injury.