Sterling QVES User Manual

Indoor gas-fired duct furnace, Power vented)

Advertising
background image

INSTALLATION AND SERVICE MANUAL

INDOOR GAS-FIRED DUCT FURNACE

(POWER VENTED)

DISM-17

J30-05392

Model

No.

Serial

No.

ATTENTION: READ THIS MANUAL AND ALL LABELS ATTACHED TO THE UNIT CAREFULLY BEFORE

ATTEMPTING TO INSTALL, OPERATE OR SERVICE THESE UNITS! CHECK UNIT DATA PLATE FOR TYPE OF GAS

AND ELECTRICAL SPECIFICATIONS AND MAKE CERTAIN THAT THESE AGREE WITH THOSE AT THE POINT OF

INSTALLATION. RECORD THE UNIT MODEL AND SERIAL No.(s) IN THE SPACE PROVIDED. RETAIN FOR FUTURE

REFERENCE.

FOR YOUR SAFETY

If you smell gas:
1. Open windows.
2. Don't touch electrical switches.
3. Extinguish any open fl ame.
4.Immediately contact your gas supplier.

Look in direction of air fl ow
to determine if your unit is
right or left hand accessible.

12/12

FOR YOUR SAFETY

The use and storage of gasoline or other fl ammable vapors and liquids in open containers
in the vicinity of this appliance is hazardous.

APPROVED FOR USE IN CALIFORNIA WHEN EQUIPPED WITH INTERMITTENT PILOT IGNITION

Install, operate, and maintain unit in accordance with the manufacturer's

instructions to avoid exposure to fuel substances, or substances from incomplete
combustion, which can cause death or serious illness. The state of California
has determined that these substances may cause cancer, birth defects, or other
reproductive harm.

INSTALLER'S RESPONSIBILITY

Installer Please Note: This equipment has been test fired and inspected. It has been
shipped free from defects from our factor y. However, shipment and installation
problems such as loose wires, leaks, or loose fasteners may occur. It is the installer's
responsibility to inspect and correct any problem that may be found.

Improper installation, adjustment, alteration, service, or maintenance

can cause property damage, injury, or death. Read the installation, operating, and
maintenance instruction thoroughly before installing or servicing this equipment.

RECEIVING INSTRUCTIONS

Inspect shipment immediately when
received to determine if any damage
has occurred to the unit during
shipment. After the unit has been
uncrated, check for any visible
damage to the unit. If any damage is
found, the consignee should sign
the bill of lading indicating such
damage and immediately file claim
for damage with the transpor tation
company.

260 NORTH ELM ST., WESTFIELD, MA 01085

TEL: (413) 568-9571 FAX: (413) 562-8437

www.mestek.com

Advertising
This manual is related to the following products:

QVED, ME