Brocade FastIron SX Series Chassis Hardware Installation Guide User Manual
Brocade fastiron sx series chassis, Hardware installation guide
Advertising
Table of contents
Document Outline
- Contents
- Preface
- About This Document
- Overview
- Software features
- PoE and PoE+ applications
- Hardware features
- FSX 800 chassis
- FSX 1600 chassis
- Specifying a port address
- Management modules
- FSX 800 and FSX 1600 management modules
- Switch fabric modules
- Interface modules
- Hot swap support
- 48-port 10/100/1000 Mbps (RJ45) Ethernet PoE interface module
- LEDs for the 48-port 10/100/1000 Mbps Ethernet PoE interface module
- Second Generation 24-port Gigabit Ethernet copper interface module
- Third Generation 24-port Gigabit Ethernet copper module with PoE+
- 24-port 100/1000 hybrid fiber interface module
- 2-port 10-Gigabit Ethernet interface modules
- Third Generation 8-port 10-Gigabit Ethernet interface modules
- Network interfaces
- Port regions
- Power supplies
- Cooling system
- Built-in mounting brackets
- Layer 3 routing protocol table sizes
- Installing FastIron SX Devices
- Unpacking the system
- Installation precautions
- Preparing the installation site
- Removing extra shipment screws (FSX 800 only)
- Installing the chassis in a rack
- Removing the slot panels
- Installing management and interface modules
- Attaching a management station
- Powering on the system
- Verifying proper operation
- Connecting Network Devices and Checking Connectivity
- Overview
- Assigning permanent passwords
- Configuring IP addresses
- Connecting network devices
- Testing network connectivity
- Troubleshooting network connections
- Managing the Chassis and Modules
- Overview
- Displaying chassis status and temperature readings
- Managing the cooling system
- Displaying the Syslog configuration and static and dynamic buffers
- Syslog messages for PCI (hardware) errors
- Managing the switch fabric modules (FSX 800 and FSX 1600 only)
- Displaying management module CPU usage
- Removing MAC address entries
- Using a Redundant Management Module
- Maintaining the Hardware
- Overview
- Hardware maintenance schedule
- Cleaning the fiber optic connectors
- Replacing a management module
- Replacing a switch fabric module (FSX 800 and FSX 1600 only)
- Replacing an interface module
- Replacing a copper or fiber optic module
- Installing or replacing a power supply
- Replacing the FSX 800 fan tray
- Replacing the FSX 1600 fan assemblies
- Replacing the air filter in the FastIron SX-1600
- Hardware Specifications
- Regulatory Statements
- Caution and Danger Notices
- Index